You are here: HomeTutorials | Passenger-Tutorial
Display this page in English | Print View
Siehe auch

Top rated tutorials

Neue Tipps
19.2.2011Map window tips
19.2.2011Which areas are not covered by my passenger network?
11.2.2011How to build a subway

How to transport passengers

This tutorial shows you how to transport passengers.

Table of contents


13.10.2004 Tutorial is online
2.6.2004 Preview of tutorial published


Which areas are not covered by my passenger network?
 Updated on  19.2.2011 by Webmaster
Comments (1)
19-February-2011 Updated tip

In the map window you can display the area which is covered by your passenger network.

Image: Map Window

You can zoom the map with the mouse wheel.

How to display the map window :
  • Click on
  • Click on the "show legend" button if the "passengers" button is not visible
  • Click on the Passengers button

Update 23-April-2005:
In recent Simutrans releases ( and later) you can show/hide the station coverage with the v-key.
How to place bus stops?
 Updated on  30.4.2005 by Webmaster
Comments (1)
You don't need to place very much bus stops in a city. Each bus stop covers an area of 5x5 tiles (in old Simutrans releases 7x7 tiles). In current simutrans releases you can show the coverage area with the v-key.

In the following image I have highlighted the area which is served by a bus stop:
http://www.simutrans-tips.com/pic/tutorials/truck_train/einzugsbereich.jpg (outdated, 110 KB)
Speed limit on city roads
 Updated on  4.11.2004 by Webmaster
Comments (3)
There is a speed limit of 50 km/h on city roads (in Simutrans and later)

You should consider this if you buy new busses and trucks.
Connect cities by rail only
 Updated on  31.10.2004 by Webmaster
Comments (2)
Connect cities with rail only (a loop track with multiple trains). Otherwise you still need 50+ busses.

Marcel Detz, 20-Oct-2002
How passengers select their route
 Submitted on  2.6.2004 by Webmaster
Comments (0)
Passengers are not selecting the shortest route. They select the route with the least number of transfers.

Passengers currently count the transfers between transportation modes.
I.e. change from bus to train = 1 transfer. They try to use the route with the least number of transfers. If there are "equal" routes, they use whichever they find first.

Note from webmaster: every change is counted (Even that from bus to bus)

As of Simutrans 0.84.8 (This will change sometime)

Written by Hajo, Edited by Markus Weber

more tips about this article

Rate this page

Rating: Average rating: 4.20 of 5  42 Votes
Rate this page:   

(c) 2002-2005 by Markus Weber

This page has been generated in 0.04503 seconds

nach oben
Rail Stations